camlex

Long time ago, somebody posted how to check IACV. Test port next to radiator cap, short TE1 and E1 and rpm runs fast your IACV is working properly. Hope that helps.

I have 97 and needs help to install basic radio w/ CD which also allow mp3, bluetooth. Please help me out. Thanks,

Hello, From driver side(Master switch) i can control all windows up and down, but passenger side window control switch works only to down that window, i cannot make windows goes up. I did try with electronics cleaner, works couple minits and stop working again. Is it time to change switch? Please advise. Thanks in advance.

Who changed your cat., make sure he knows what he is doing. I had same problem, that guy change two-three times, I took it to other mechanic he install from orailly"Walker" brand @ appro. 286,000 miles today i have over 351,000 with out any problem. total cost was $240 including part+welding labor Hope that helps.

Never heard ECM get shorted. what was code first time, and now?

I did replaced in my '97

what about Toyota dealer, you have 98 camry V6

I don't know why, but I did opened radio, I needs to replace IL907 bulb. bad thing is, I needs to solder that bulb. I put it back and radio still working as use to.... Talk to Manufacturer, cost of bulb is $10 and shipping is $10. vs whole panel with 12 bulb was $76(you don't needs to solder anything). Car has 351,562 miles, might I will leave this project unfinished. Thanks for everyone's input.

I did replaced LCD last year. I was planning to replace radio buttons (Tape, Cassette) back bulb. Thanks,

first, you needs to get code Go to autozone....

I think this project is finished without even starting. I know where the Cassette and tape buttons are but it just doesn't look right. Thank you.

Hello, May be i posted earlier, but i like to fix this problem. At night, i can see only AM and FM lights in radio. No cassette, or CD. it's possible to replace bulb. When i called Stealer for bulb part no, He mentioed, i need to replace whole CD player. Needs your help. Thanks in advance.

UPDATE - I didn't get to the IACV , I noticed a bad vacume line while I was in there, I replaced it, now here is my next question.. Cold engine, started in park, RPM's are at 1200 for less than 10 seconds, then 1000 RPM for less than 30 seconds, then I put it in gear, and they dropped to 800, after engine warmed up, rpms were at 700 or so, even in park. Is this normal ? I understand an engine runs higher when cold, my question is, does a normal engine run at lets say 1000 at the highest, and down from there, and so forth ??? the temp is about 60 degrees F outside.. . thanks ! I'm hoping all my problems are fixed and I can be done with this.. . . I think that's normal rpm...

Good Luck.

everybody talks about oil, what are other factors? Engine Cooling system !

It's 97 ES300 with 351,100........

buy TB cleaner and spay inside that hole.

I have 351,000 miles and never opened IACV, when I clean TB, I spray lots TB cleaner in IACV hole. Hope that helps.

did you try to clean outside of TB where cable drive the TBplate? idle should be 700-800 rpm

make sure they DON'T use chemicals, Just change trans.oil.

I will take Two. How much?

i always use wagner, no problem, (Thermo quiet)

please check top mount.

Yes, I do. Later, may I will post some pictures

If i understood correctly, it can be inner tierod, strut mount or lower arm control. Let see if i can explain what i understood. when you stop on stop light or sign or just you are in drive position. if you turn your steering wheel right no noise or vibration on steering wheel but when you turning to left you hearing noise and feel vibration. oh! i don't know, do feel vibration on steering wheel?