Jump to content

Recommended Posts

Posted

I have a 92 SC400 with 167k miles. Car is in relatively good condition considering it is 20 years old. However I do have a problem with getting no heat. I have replaced the thermostat thinking that was the problem, but alas still no heat. Heater blows cold even with temp control cranked all the ways up. Any/all ideas appreciated.

Thanks In Advance

  • 5 months later...
Posted

This is the notorious heater control valve acting up. This is by the passenger sidefirewall where the the wiring harness goes through the firewall. Replace it with a new used one. make sure the vacuum lines are not unplugged allowing it not to open and close properly.

  • 1 month later...
Posted

I had a similar problem recently and the only thing I needed to do was a coolant flush. I hadn't done it in way over 60k miles bc it was really clean etc. The second I did a coolant flush, not just a top off or whatever, the heater was back to its prime. sometimes a dirty heater core wont allow you the hot air you want inside the cabin.

Cheers

  • 5 months later...
  • 3 months later...
  • 4 weeks later...
Posted

Heater Core may be Plugged ???? Reverse Flush is Easy enough....Try It ^^^ :)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×
×
  • Create New...

Forums


News


Membership


  • Unread Content
  • Members Gallery