sha4000, you are correct, the engine is turning but will not start. I did not hear any spark. No codes were read. I show the picture above because I was not sure (at the time) if I installed them correctly.
I later found out that the instruction on Lexls was incorrect. The contact points (wire) should be at the yellow arrows (not at the opposite position as shown in the picture below). After fixing the errors, my car is running normal now. If I had taken pictures of the distributor rotors when taking them off, I would not have any issue. The positive outcome from this is I feel more confident with timing belt work since it is more straight forward.
Thank you for getting back to me.