Front License Plate

[wh2]

The front license plate on my 2010 RX 350 keeps getting bent up at the bottom at car washes. The mounting surface allows the plate to be attached via 2 screws at the top. The surface provides backing for only the top 2/3 of my NJ plate, thus I can't use the 2 lower edge mounting screws. Other vehicles I've had came with full plate backing, and car washes never caused a problem.. I think this is a poor design. Have any of you who have req'd front license plates experienced this bending, and/or have any fixes?

[BlueSurf]

Go to PepBoys or any auto store and you can buy a license plate frame with a metal back plate. Its sold in one package together. about $20.00 You can purchase new screws with bolts to secure your plate at the bottom. If you do this you woun't ever have a bent plate. I have it on my 450H. It works perfect and looks great.

[wlk12]

Go to PepBoys or any auto store and you can buy a license plate frame with a metal back plate. Its sold in one package together. about $20.00 You can purchase new screws with bolts to secure your plate at the bottom. If you do this you woun't ever have a bent plate. I have it on my 450H. It works perfect and looks great.

Good idea! You might also keep your eyes open for a new car wash :)

[LexRexBlue]

I had the same problem on my RX400h. My new car hasn't been to the car wash yet. However, I came across this! http://www.detnews.com/article/20100909/AUTO03/9090370/1148/auto01/License-plate-holder-protects-front-bumper