Lexan Posted July 4, 2004 Share Posted July 4, 2004 :( Okay...here's the story. I was washing my car this fine 4th of July, and decided to simply hose of my engine..just a garden hose nozzel. When I started the car and pulled into the garage, the check engine light came on when I put it in park, then I noticed it was ideling a little ruff. I turned it off, waited a minute and restarted, this time it seemed to be running on only 4 cyl. and had a few small backfires. I shut her down and popped the hood looking for anything obvious, but found nothing. I let it sit for a few hours, started it it, and it sounded fine, not even the light came on...so I drove around the block..it ran perfect, pulled in the garage, put it in park and the light came back on! Turned it off, waited ,re-started it and it's running terrible again! Starting to panick! Quote Link to comment Share on other sites More sharing options...
SKperformance Posted July 4, 2004 Share Posted July 4, 2004 water in the dist cap, did you check that . Never apply water to a cold engine or one that is off it pools and causes all sorts of problem Quote Link to comment Share on other sites More sharing options...
Lexan Posted July 5, 2004 Author Share Posted July 5, 2004 Where is the ditributer located? Is it possible the the coil connectors got wet? How do I clean either? Thanks Quote Link to comment Share on other sites More sharing options...
SKperformance Posted July 5, 2004 Share Posted July 5, 2004 air dry Quote Link to comment Share on other sites More sharing options...
SEAN_VANCE Posted July 6, 2004 Share Posted July 6, 2004 the distributor is that black opctopus looking think with all the wires coming out of it that go into ur spark plugs.....Take it appart and blowdry everything in there....never hose the engine like that. When you clean your engine u have to be careful with electronic components if its just water it should be ok, it definitely sounds like your timing (distributor problem) so thats probably what did it....if it got really wet I would change the rotor too just to be safe...it slike 15 bucks in auto part ..its inside distributor Quote Link to comment Share on other sites More sharing options...
Lexan Posted July 11, 2004 Author Share Posted July 11, 2004 B) Thanks for the suggestions..all it needed was to dry out. I learned a lesson that time..thanks again! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.