Jump to content


Engine Surges Then Dies. I Have Searched, But Have Not Found A Solutio


fly_S2K

Recommended Posts

Hello all,

Well it's happened to me, the dreaded surging idle and stalling engine that often occurs with our early gen Ls400's. I have searched but nothing's actually pointed me in the right direction with my problem.

Here are the symptoms. My 1990 LS400 drops to very low RPMs after a few minutes of driving. It will sometimes drop low then surge up to about 2000rpm or flat out stalls.

However, this does NOT occur after a long drive or anything, it will happen after 2 mins of driving. Even when I am driving around 40MPH, the car will slow down then start surging or stalls. No matter how much throttle I add, the car will drop RPM's (200-300RPM) then surge upwards or just flat out stalls. It will not allow me to drive.

I have spent 2 days searching on this common problem without results, as everyone else's seem a bit different. Such as the 94-95 with the ECM problem or 1st gen's like emyself doing a TB cleaning and MAF cleaning which solves the problem.

I've taken a look at my MAF and it looks clean. I'm not sure what to clean on the TB but I do not think that is the problem. I do not think it is the idle control valve because my problem will occur even when im on the freeway doing 60.

I want to say it is a bad MAF, but I don't want to go out and buy one without a second opinion. Could someone point me in the right direction? Any input would be greatly appreciated!

Thank you.

Link to comment
Share on other sites

Surging, per the factory chart is #1 SWITCH CONDITION SIGNAL CIRCUIT which includes the park/neutral position switch. The Air cond switch signal. And the Throttle position sensor. The second area to look at is the fuel pump control circuit.

These are listed as the #1 area for a prob. with surging, poor accel., Incorrect first idle, rough idle, idle hunting, high idle, stall after pedle depressed.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



×
×
  • Create New...

Forums


News


Membership