Headlight Allignment...where And How?

[TRDlover]

recently i have noticed that my headlight are not aiming stright, does anybody know where and how i can re-set the allignment of the lights??

[TurboGS300]

Should be very obvious when looking at the headlights. Do it on a level surface and use the levels. <_<

[deadmilenko]

There is two different ways to adjust the headlight beams, Vertical and Horizontal.

First make sure that the vehicle is on a level surface like Turbo said.

Use this gauge for the Vertical adjustment The bubble of the gauge should not deviate from the center of the gauge by more than 2 marks to either side of the gauge.

If the bubble is out of the acceptable range for the beam angle gauge, adjust it using the inner bolt (closes to the engine).

The Horizontal gauge is a little harder to see. Here it is on the passenger side It is located inside of the headlight lens on the lower outside lip of the lens assembly. This picture show it on the drivers side . The mark should not deviate by more than one more to either side of the gauge. If the edge of the lens does not match the "0" mark then adjust the lends by using the outer bolt (closes to the fender).

The hardest part is finding a level road. Let me know if you have any more questions.