Verbal Posted August 4, 2008 Share Posted August 4, 2008 Ok, i have a 92' SC300.... this weekend i installed a ACT Stage2 clutch, now when i start it up and push in the clutch....it won't disengage. Here is a little history on the clutch, it would slip real bad before and sometimes wouldn't shift/ go into gear.... i figured it was the clutch, which upon removal i found the stock pressure plate was FUBAR. I have bleed the clutch many times after the install, i also replaced the slave cylinder. I am thinking the master cylinder is the culprit. The pivot arm moves, but only about an inch...if that. Any advice would be great.... TIA! Quote Link to comment Share on other sites More sharing options...
SC300Drifter Posted August 24, 2008 Share Posted August 24, 2008 Try replacing the master and bleeding the system. Did the new clutch work at all after the install? Any vibrations at idle? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.