I Blew It

[air12290]

1 was told my 90 LS400 needed a new ignition control module.. which, easily enough is attached and accessible. I took off the two connectors, and took of the 2 screws to the old one. Unfortunately, when I went to put on the new one, I had purchased the wrong one, and the plug in did not quite fit.. so I cleaned up the old one and went to reattach.. however, when I went to put the two plug on connectors back on, I wasn't very careful on the second one.. and bent one of the 6 pins.. so even when I get the correct ICM, that connector won't work.

Question is, the connectors that plug ON to the ICM.. where do those wires go to? I think I can buy a connector with the wire, but not sure what it leads to

thanks

[vyhanh]

Hi,

I think that if you can get a wiring diagram, it will show all the wiring, their colors, and where they are connected.