gunni
-
Posts
35 -
Joined
-
Last visited
gunni's Achievements
-
If you can send me the instructions it would be great :) If you can post it here or my email...wich ever is better for you, My email : hrabbagas@simnet.is
-
Yes it was
-
I tried to reset the ECU....... the car ran fine for a little while but then started again the same old habit..the check engine light was on the whole time.
-
OK I will try this....But what wil this DO ?????
-
Hi Guys.. I am wondering if you know what color of the wireing to the MAF connec. is for the IAT. (see picture) Also Smooth1; If I replace the MAF (as i did) isn´t the IAT new as well its in the same unit or ??? (see picture)
-
Is a wire diagram available somewhere or does it even exist ?????
-
Can you give me some advise how to check these things or just where to start ??? Thanks
-
DO you know how I can check the connections and the wire conditions??
-
Hi guys...Didn´t work...I was wondering do you know how I can check the MAF connector to see if there is a fault in the plug ??? The MAF is good and I can see the IAT sensors the are also clean and Good....
-
Ill check this out tomorrow its 4:30 am here where I am and rise and shine 7:35am I´ll keep you guys updated tomorrow about how it went. Thousand thanks to you guys...
-
...
-
So I will remove the hose on the metal connector.and leave the other one like this ?
-
Quote :::: I think the hose you have on the red arrow where there shouldn't be a hose goes to 90910-12220 in the diagram. Am I getting it or am a just a dum *BLEEP* :)
-
Ok so I´ll take that one off..but are these then right ?
-
OK so check these pics..Should the one in the first pic go where....I am so lost here guys sorr y
