Scotty C

Following are the results from Microsoft Copilot: The 2007 Lexus LS460 4.6L V8 does not have a transmission fluid dipstick. Instead, it uses a check valve on the bottom of the transmission. To check the transmission fluid level, follow these steps: Ensure Safety: Park your vehicle on a level surface and engage the parking brake. Warm Up the Engine: Start the engine and let it run for a few minutes to warm up the transmission fluid. Locate the Check Valve: The check valve is typically located on the bottom of the transmission, underneath the vehicle. You may need to raise the car using a hydraulic lift or an underground bay to access it. Remove the Check Valve Plug: Use a wrench or socket to remove the check valve plug. Be cautious as some fluid may drain out. Check the Fluid Level: Insert your finger or a clean tool into the check valve hole. The fluid level should be close to the bottom of the hole. If it’s low, you may need to add more fluid. Add Transmission Fluid (if necessary): If the fluid level is low, add the appropriate transmission fluid. The 2007 Lexus LS460 requires approximately 7.7 quarts or 7.3 liters of transmission fluid12. Reinstall the Check Valve Plug: Once you’ve checked the fluid level, securely reinstall the check valve plug. Verify Proper Fluid Level: Start the engine, shift through the gears (from P to 2L), and then return to Park (P). Recheck the fluid level to ensure it’s within the proper range3. Maintain Vehicle Level: Keep the vehicle level while adjusting the fluid level to ensure accuracy4. Remember to use Toyota Genuine ATF WS transmission fluid for this vehicle. If you’re unsure or need assistance, consider having a mechanic perform the check for you. Regular maintenance of your transmission fluid is crucial for optimal performance and longevity of your vehicle.

2007 Lexus LS460 w/192,000 I took a 3-hour trip. While in traffic on the interstate, when accelerating in D (not manual) the engine "revs", not engaging as if in neutral. Shifted to manual to overcome, which seemed to work. Cruised at 80 MPH for 3 hours. Upon getting off the highway, the car would drive but it was as if It was starting in 5,6,7,8th gear...a very sluggish start. Shifted to Manual (1st/2nd) which did NOT work. No warning lights, no visible leaks, no smells. When shifting into reverse, I detected a "thud" or non-smooth shift. No way to check fluid since it's sealed. I am in rural Illinois--nearest dealer is 90 miles away. Called my dealer for ideas. Short of a diagnosis, not much insight. Need to make it back home which seems doable based on behavior. Thoughts?

Thanks for the opinion/guidance. I have been getting some "push back" from a few mechanics that replacing the bushings on perfectly good control arms (IMO) can "mangle" or damage the arms. I agree with you. How difficult is it to replace them for a skilled mechanic? Also, rubber vs. urethane. Does urethane result in a stiffer/harder ride? Does it have greater longevity? All the parts look like Lexus OEM, yes. Cost? BTW, I just replaced rotors, calipers, pads, and inner/outer tie rods on my son's Honda Pilot--I am capable and versed.