DSM2GS

I should have phrased that better. When I roll the window up (using auto up) it will close all the way and then roll down about half way. When I roll the window up (using manual mode) it will roll up completely unless I push it too far and it will roll down half way again. I'm assuming that I need to reset the anti pinch mech. to alleviate this problem. In the PDF it says to remove the service panel. When I took off the door panel I am met with almost a full steel panel, there are small access doors. Unless I remove the service panel, I cannot even see the window motor. Complete factory service manual on CD anyone??? I saw a couple of them on Ebay, any reputable dealer that anyone has purchased a service manual from???

I got the window fixed, it had come away from the rubber and metal bracket that lifts it. Is there a PDF on how to remove the service panel in the door? Or alternatively is there a way to reset the "anti-pinch" mecanism with out rotating the window motor?

Thanks, I did search for removing the door panels but I didn't find anything for the rear. The PDF helps a lot, is there anywhere I can download or purchase a complete service manual on CD?

It's pretty common on the 1st gen GS3's, not sure about the GS4. Usually on the GS3 though if the regulator breaks the windiw falls down and won't stay up. So check the motor and tracks as well <_< To motor is still working (I can hear it), there is some movement of the window but it won't rool down all the way. You can slid the window down by hand, so I need to get this fixed asap. It would help if I could take off the door panel to see whats going on. Anyone have instructions?

I've done some searching and I can't find a topic relating specifically to GS400 and window regulators. The other day while rolling down my rear drivers side window, I heard a loud crack and soon after the window would not completely close. This problem sounds similar to a problem that happens on some SC cars. Anyone have this issue on their GS400? Is there a DIY fix? TSB? A FAQ or instructions on how to remove the rear door panels? Part #'s?