Hi All, glad found this forum. We have a 2003 RX300, one day the CEL and VSC came on. We checked the OBDII code and it was a bad Oxygen sensor. I replaced the sensor and sure enough the CEL went off. The only light remaining on is the VSC. I tried the Toyota Procedure to do a Zero point calibration using pins 4 (CG) and 14 (Ts) in the procedure found in http://www.toyota-4runner.org/attach...-dtc-c1203.pdf
It seems everything is fine till I get to point 11 on that procedure. Instead of the VSC light blinking, I get the ABS light blinking. And as soon as i start driving the car the VSC light comes on again.
One more clarification just to make sure Im doing this right. In step 9, I short the pins and they remain shorted right?
Also I read somewhere that it may actually be TC pin that needs jumping not TS. Any truth to that?
Thnaks I much appreciate any feedback