Jump to content

ondre1980

Regular Member
  • Posts

    4
  • Joined

  • Last visited

Everything posted by ondre1980

  1. What's a motorvac? What fuse do I pull to clear the codes again? Thanks, Ondre
  2. Hi, My 94 es300 has 135k on the clock and the mil code is P0135 (o2 bank 1 sensor 1). I searched and found this thread where after the o2 sensor was replaced, the egr threw a code. I haven't taken the o2 sensor off yet, or cleaned the EGR. What is the most cost effective method to alleviate my problem? Should I clean the EGR passages first? Or should I test the o2 sensors resistance? I don't want to buy a new sensor if I don't have to. Thanks :) Ondre
  3. Blake918, Thanks dude, I will get it up to AZ asap... I'll try and tell them it's an 05 and see if they notice :)
  4. Hi, My 94 es300 has been getting a cel for a while... immediately at startup and never goes off until car is off. I replaced my PCV, knowing it was bad, and disconnected the neg battery cable for a few minutes to see if I could clear the code this way. After driving for a while the code came back. I assume the PCV is not the culprit, and would like to check the code. AutoZone only scans 96+ vehicles (odb2?) and I cannot find any information here on how to DIY... One of my vehicles, install a jumper and the CEL will blink it's code. The other has a LED on the ECU that blinks the code. Does the 94 es300 have anything like this? If no, who can tell me the code besides the stealership? Thanks, Ondre
×
×
  • Create New...

Forums


News


Membership


  • Unread Content
  • Members Gallery