lostpark

Did you know how to remove the driver side door lock assembly for RX300 2003? Thanks,

I got the actuator and did it on my right rear door, it was working great. Now, I am attempting to do on the driver door. I have a tough time removing the driver door actuator. How do you remove the driver door actuator with the door rod connected to the lock assembly? Please help!!!!!!

Do you know if the 2003 RX300 would use the same actuator and where to buy it? My driver and right rear doors are not locking remotely.

Thanks,

lostpark

I had a common problem with my right rear door actuator. It kept getting weaker and weaker slowing down and eventually not working at all. I did a search on Lexus actuator on ebay and came up with an inexpensive universal actuator which you will see below in the installation instructions.

When I opened up the panel in the door it seemed to be near impossible to install this new actuator in any way. After dinking around trying this or that. I decided

I would attach the actuator rod to the manual locking cam lever on the old actuator to try and make the new actuator work. This requires leaving the old non functioning actuator and parts in place.

1. Drill a hole the same diameter as the new actuator rod in the wider part of the manual locking cam lever on the old actuator right next to the where the manual locking wire hooks up to the old actuator cam lever.

2. Cut the new actuator rod to fit your application. Bend the new actuator rod end the same way the manual locking wire is bent. Grind the rod end a little thinner as it is tight under the locking cam lever and it will rub on the housing otherwise.

3. Have the new actuator attached at the other end of the rod first. Attach the rod through the hole you made in the cam lever the same way as the manual locking wire is attached.

4. Reinstall the entire door locking mechanism back in the door leaving the actuator hanging out the access hole.

5. Attach the mounting strap to the new actuator using 2 long bolts place 2 spacers or multiple washers between the strap and the actuator this way

you can put the actuator just inside the access hole in the door (spacing it carefully not to interfere with the power window)

thus allowing you to screw the strap to the outer door panel.

6. You will need to cut a little of the white thin plastic protector shroud on the old actuator to make good clearance for the new actuator rod coming out through the door access hole.

7. Adjust the new actuator for locking and unlocking slack before fastening the mounting strap with screws to the door.

8. Splice the 2 new wires into the 2 larger wires coming off the old actuator (splice them in don't cut the old wires) (You may have to reverse the wires (before soldering or crimping) to make sure you have them unlocking & locking in sequence with the rest of the door locks)

It actually works better than the original with shipping it costs less than 15.00 for the parts. I used lock washers on the bolts. It would probably be good to use locktight on all screws. I have no pictures, but If you read this carefully you know it can be done and is not very difficult. I haven't tried this on the front doors yet, but will eventually have to. I hope it goes as well for me... At least it wors for the back doors. Good Luck to you!... Indi

I have a 2003 RX300 with the driver and right rear doors does not lock remotely. I think it is the door actuator is a problem. Lexus told me the parts are $365 a piece. Does anyone know how to repair the door actuator cheaply compare to Lexus parts?

Many thanks,

Lost Park