rmccath

can you provide more information, its under warranty i hope, did you have a complete failure, or was leaking discovered during maintenance?

This is a recall, My RX400h is in stall mode, happened while driving on the freeway went into fail drive state. Had to have it towed to a dealership.

Currently in the process of getting my inverter replaced. Any suggestions for people that have had it done already? I will give out my feedback when process is complete.

I did call into the dealer and my electric Power Steering rack had been replaced. I gave them my VIN# and they were able to look that up. well thank you for the comments and if you know of any other trouble shooting ideas please pass them along.

Thanks Again,

Russell

I have an electric power steering system so i don't think their is any fluid to check?

Has anyone had a problem with their Power Steering not working properly. I currently have my P/S light on in my dash and my power steering in not working properly. Any ideas or suggestions?

Thank you,

Russell

2006 RX400h

Maseace,

One quick question. Where did you get those PDF Documents on how to remove the inverter?

Thanks,

Russell

Good points, this might be something I want to stay away from. I am dealing with a rebuild the damage is not too bad but I am missing everything up front like the radiator, condensor, cooling fans. I have attached a picture. I was wondering if anyone has a guide to show me everything I would need to purchase to get this car back up and running. Any manuals or guides would be much appreciated.

Russell

Lemon I have a small dent on the bottom black pan cover to my inverter, I just wanted to take the inverter out and make sure the dent didnt do any internal damage before putting this car back together. I have read that the inverter is the main component in this hybrids so i thought i would make sure everything is all right there before moving forward.

Thank you for the great information I see that Maseace is from Washington State which area of Washington State are you from? Also it looks like when I take out the HV Inverter I will have to re-install quite a few other electrical systems like shown in the 4th document that you sent me labeled the Initialization Procedure. Just wanted to make sure I have this correct. Thanks again for all the help.

Russell

I was looking to see the step by step process of doing this. The research i have done shows me the precaution steps so you don't get electrocuted but I was looking for a little more detail.

Thanks,

Russell