03 GS300 Sport

Never had to check on this issue with the pump.......but guessing here shouldn't it be in the trunk? Below the trunk liner/spare tire right above the gas tank?

Biggest difference I've seen........ Adds a nice placard that says, "SPORT" and maybe the rear wing?

Yea I'm not too entirely sure on the color but to me it's burnt orange! I love it, took me a lot of patience and waiting around for me to get this beauty. How much are you getting the 12" for? On the side note.... are all air free sub cone's made of a cardboard looking material as ours? The Mark Levinson brand I thought was pretty good and when I heard the rattle couldn't believe it was the sub! Subs I've seen at stores and in other peoples vehicles have a black cone material that looks and sounds better. Just figured this was the case as well.

With another Lexus sub that I got pretty cheap from a friend. Sounded better of course without the rattle.

Hello to all, I'm new on this forum. Did a search few times about removing the back seat for my car, found some but....couldn't find anything with pictures. I had to replace the sub, sadly it started to rattle about 1 month AFTER my warranty ended :-(. It's fixed but thought I'd post some pictures for anyone needing them. Enjoy... :D Back seat: Pull up on the lower part on left/right sides. You can feel where it meets with the frame... Slide out towards front of car and up, there are the rear hooks holding the lower seat in place: Remove lower seat. Removing backrest seat you have 4 bolts, 2 nuts, 3 head rests. 3 bolts are along the bottom adjacent to hooks holding lower seat in, 2 nuts underneath left/right head rests, remove center headrest: Bolts along the bottom: Nuts (these took a while for me to find!!): Remove 3rd brake light. Small regular screwdriver underneath back to lift up...slide towards front of car. Disconnect plug : -(just so happens my neighbor decided to drive right by with their white GS300!) Remove child restraint seat holders/clips: Slide backrest up and forward to remove. Optional...You can either remove the 3 seatbelt holders w/ 3 philips screws each or stick a small awl inside hole to pop open the seat belt clamp: There are clips for the back shelf you can pop them out from within the trunk (could use 2 people for this). Sub is visible and can be easily removed..careful with the wiring! Hope this helps some for those needing pictures ... ~Alex