hiholex

Hi, Can anyone assist me in providing some guidance and instructions on removing the silver plastic engine cover. I do not want to pull on the cover and break something. I want to remove the cover to install a F Sport Intake hose. I do not see any screws or clips to take off. Thank you in advance for you advice...

DCFISH You did a great job in the modification. Did you have to cut the intake from both ends to make it fit? How and what did you use to connect the intake to the air box? It is such a great project that I would like to try it under your guidance and instructions.....

The ticking sound could be from the direct fuel injectors at each cylinder. At idle in park the noise may be heard, but as you drive you should not be able to hear it. If you still hear the ticking as you drive and it gets louder as the rpm goes higher, then it could be the valves or something else.

I also noticed that the lexus cargo net works also as a elastic item holder as well as a net to hold things flat to the floor. I know on my 99 gs3 there are d-rings on the trunk floor but no anchor up high to use the net like a bag style between the tail lights. Am I missing some anchors around the tail light? Should the net be used with the d-rings under the speaker shelf? Again there are d-rings on the floor and not up high. Looking forward to all the helpful comments.

Thank you GUY for the door diagram...

Thank you Guytelefunken for the info.... The speaker seems to work fine under moderate and high volumes and not at low volumes. The stereo is used the majority of the time at low volumes. Will your diagnosis still be true for the reverse volume situation. Thanx...

I would like to ask you all if the amplifier is in the head unit? Thanx...

My front passenger door speaker on my 99 gs3oo cuts in and out. I would like to know if this problem could be a head unit problem or an amp problem. Where is the amp located? Is it the door speaker problem? Has anyone experienced the same problem? Thank you for your help and comments...

Thanks for the info and the links to ebay...Is there a way and place where I can purchase the tube and connector for the modification without cutting the air box and use the air mass sensor as is. I would like to keep the mod reversible back to stock if possible... Thanks

I would like to know where you can get a short air intake tube, silicone connectors that will fit between the air box and intake manifold with minimal or no modification at a good price. Thanx....

Hi Charles, You mentioned that greddy has a front strut tower bar for a second generation gs300. What is the part number and the price for the bar... Thanks

I made an error in this posting..

Thank you for finding the correct 06 toyota picture. My reference picture at toyota.ca is not the car in the car commercials in canada. A lexus owner will appreciate the qualities and the toyota owners will always aspire to own the qualities and status of a lexus. Example, the camry is the sister to the es300 as the gs is the brother to the avalon. I'm just disappointed that similarities between the lexus and the toyota's are becoming so close. I take great pride in owning my lexus and I do not like lexus counterfeits made by the parents. If the similiar car was made by another company, I would not hesitate to trash that company. But beause it is in the family,"No Comment". There will always be a group of potential lexus purchasers that will buy toyota to save a buck and to buy a good counterfeit. What's the difference between a Rolex and Timex copy? One person knows he has it and the other knows he really wants it.

I would like to ask fellow 2nd gen gs owners whether anyone has tried the tire size 245/50/16 on factory wheels? How's the handling? Some of the tire sites use 7.5 inch width rims for specs and others use 8 inch width rims for specs. I do not mind going to a lower profile with out effecting the over all handling and balance of the car. Will the 245's fit in the wheel well without mods. With the 245's the width will increase by 2 cm (one inch) and the overall diameter increases by 1.5 cm (half an inch). Will this size work? The reason I am asking is that pirelli has the p-zero nero m/s tire that i like but it does not come in a 225/55/16 size. The closes size is 245/50/16. Thank you in advance for your comment. Looking forward to all your comments.

The avalon can be seen at toyota.ca. The picture will show a similiar car with a slightlydifferent c-pillar.

The o6 gs is a great looking car with all the right features a sport luxury car should have and need to attract present and new gs owners to buy. My concern is how lexus/toyota is marketing this new car. In Canada toyota is advertising the new toyota avalon on tv. Essentially the new body of the avalon is the same body of the gs. I was considering a purchase of a new gs, but I would prefer the gs to be more different. The profile of the two cars are essentially the same. If I was to pay 70 to 80,000 dollars cdn for the new car, I would be totally disappointed if I was mistaken by a comment like " Nice toyota", "nice Avalon". To most people that are not die hard lexus fans, will get the two cars mixed up. Toyota should have released and marketed the gs first to elevated the gs above the avalon as flagship icon cars. Now when you buy a gs, it can be construed as a avalon copy not the other way around. I was looking forward to seeing the car and purchasing one, but now I have decided not to buy one at this time. I feel that my second generation body style is still more exclusive. My decision to purchase my gs was largely made on the fact that the car was unique and exclusive. Now the new car is a copy of a toyota avalon. I am disappointed by the actions and decisions of lexus to allow the gs brand to loose its percieved exclusiveness... I hope someone from Lexus or Toyota is reading this comment and can comment and prove me wrong.

I have 99 GS3 with a stock sound system with numbers and symbols periodically appearing and disappearing. Do I have a loose connection, bad display? What can I do to repair this? Is it something I can do myself? Can it be repaired? Does anyone else have this problem? Looking forward to your comments...