JETSFAN

WHEN MY CAR IS LWO ON FUEL, A YEELOW LIGHT COMES ON UDNER THE EMPTY IN MY FUEL GUAGE. BUT I DO NOT RECIVE AN AUDIBLE WARNING. DOES ANYONE KNOW IF I AM SUPPOSED TO GET AN AUDIBLE? IT IS USELESS WITHOUT ONE.

Once you shift back into drive - sometimes it does cancel the I Agree and sometimes not. It seems like the longer you are in reverse it doesn't cancel it. Usually works about 90% on the I Agree. It attaches to the back of the DVD unit in the trunk. If you open the door under the trunk mat - the one with the jack in it, you need to remove that tray. There are 2 plastic 'push pins' one on either side - just pry them out with a flatblade screwdriver. Then slide the tray towards the rear of the RX while lifting it out and you will see the DVD unit on the right side. You just unplug the cable closest to the front of the car and plug in the LP, then plug the cable you removed into the other end of the LP. - replace the tray - done. When you re-start the car, the navi firmware will re-load, you will see this on the navi display - just let it finish and that's it. BTW, I have the LP3-BASIC - for $99.00 I think it's well worth it. -Ken I removed the two pins on the side of the jack Tray but was unable to pull out the jack tray. It appeared that there was a piece of wood (toward the front of the car) with some type of screws, that was preventing me from pulling out the jack tray. Anyone else esperience this?

Once you shift back into drive - sometimes it does cancel the I Agree and sometimes not. It seems like the longer you are in reverse it doesn't cancel it. Usually works about 90% on the I Agree. It attaches to the back of the DVD unit in the trunk. If you open the door under the trunk mat - the one with the jack in it, you need to remove that tray. There are 2 plastic 'push pins' one on either side - just pry them out with a flatblade screwdriver. Then slide the tray towards the rear of the RX while lifting it out and you will see the DVD unit on the right side. You just unplug the cable closest to the front of the car and plug in the LP, then plug the cable you removed into the other end of the LP. - replace the tray - done. When you re-start the car, the navi firmware will re-load, you will see this on the navi display - just let it finish and that's it. BTW, I have the LP3-BASIC - for $99.00 I think it's well worth it. -Ken I removed the two pins on the side of the jack Tray but was unable to pull out the jack tray. It appeared that there was a piece of wood (toward the front of the car) with some type of screws, that was preventing me from pulling out the jack tray. Anyone else esperience this?