unreal

i have a couple pics, i just replaced the lower ball joints and tire rods like 2 months ago and didn't drive the car for a month.

After changing the tire rods and lower ball joints of the gs300 2nd gen, i accidental must have broken the abs sensor, cant find a break in the wire. changed tires and aligned, only recently i had the windows down and radio off and noticed that sometimes driving straight my wheels will sqeal like they are skidding. usually if it goes away and smooths out it will happen again when I hit a bump. But that isn't the only issue. the tires will also pull to either side and if i turn really sharp it will pull faster towards the end of the turn. I had the wheels off the ground and spun the front tires, it would make a small noise and seem to do it at the same point in the turn. I hope someone understands what i am saying, i can only assume it is 2 of the 3 probably issues..... 1. rotors are either warped or rusted 2. bearings are shot 3. cv joint messed up? thx in advance.

ugh all down, anyone still have these somewhere? i have a gs300 2000

As i am driving i notice with the windows down a slight tire squeal from my front right tire. Also when i hit bumps in the road sometimes my car will pull to the right or left and i have to force the wheel back to straight. Do you think it may be a cv joint or bearing issue? i already had it aligned. also i mgoing to take out my starter and thought i found a thread here where it was step by step for my car and had arrows pointing to the bolts needed to be removed. thx in advance.

thx, good idea. what a pain to get it out, but the passenger side is easier. Ill switch it out and see. thx. looks like rewiring wouldn't be so bad except or the tubes in the way hehe.

I thought the bulb was busted and had it sitting out of the houseing and tapped it and it came on. I put it back in and doesn't work. You think its the electrical or dirt in the connector or the terminal on the bulb? gs300/2000

I bought the car about 3 years ago. I have the paint match from advance autoparts for touchups, but it seems darker, my guess is due to time with it fading. However it seems there is a plastic film that is peeling all over the place. The car was drivin in michigan for a year when i was there, so salt might come into play here. What can I do for this plastic coat? do i have to redo the entire cars paint job?