Jump to content


antwon_a2d

Regular Member
  • Posts

    2
  • Joined

  • Last visited

Everything posted by antwon_a2d

  1. I understand the rules. I do have a problem right now I need some forum members to maybe help me with. Maybe some other forum member can post for me until my status changes. I have a 1993 Es300 with 167K Miles on it. I had it sitting for nearly a year due to financial reasons. I recently made some pretty major repairs to it including, all front oil seals replaced, timing belt/water pump replace, AC compressor and dryer replace with R-134 upgrade, and some interior fixes. I had the transmission replaced (year ago) where I have about 10K miles on it. Now that I have it out of the shop and have put 300 miles on it (this morning) I have noticed since getting it from the shop that when starting it up and driving it without a 20 minute warm-up the car runs like a 2 cylinder. After it gets good and warmed up, it drives okay. What could the possible problem be for the lack of power? What can I do to increase the low-end performance? Someone please let me know before I have to go to another shop and pay for this info. Thanks, antwon_a2d Sorry Seafoam question forum. I was responding to a rules note on my page. As far as the seafoam question, in Georgia, you can get it at AutoZone autoparts. Are the any DYI's that are available on this forum for the best way to administer it to a 1993 ES300? antwon_a2d
  2. I have a 1993 ES300 with 166K Miles on it. I recently had the timing belt/water pump, front oil seals, valve cover gaskets replaced, and upgraded AC with a Compressor exchange. The tranny was replaced at 145K. I just got the car back a few days ago after it was sitting for nearly 6 months awaiting the oil seal repairs and AC repairs ($1500 total). Now when I start the car in the morning (in Atlanta Georgia), and attempt to drive within the first couple of minutes, it seems as if I am running a 2 cylinder versus a 6. What can be the problem? Any suggestions? Oh yes, If I allow the engine to warm for at least 10 minutes pryor to driving, it hesitates just a little into the first set of gear changes then it is off to the rases. Please give me your suggestions.
×
×
  • Create New...

Forums


News


Membership