Jump to content

timspell

Regular Member
  • Posts

    13
  • Joined

  • Last visited

Everything posted by timspell

  1. Can any one tell me where low oil pressure sending unit is located on the engine. And if i screw in a pressure gauge , what is the oil pressure at idle and at higher RPM's
  2. Any one have a problem with the low oil pressure indicator light or failed oil pump.
  3. Knock sensor torque is 29 ft-lb. Doesn't say you have to put anything on the threads but you might want to try some anit-seize if you think you're going to take them off again sometime. THANK YOU FOR THE INFO
  4. i have the intake manifold off and have removed the old knock sensors. do i put anything on the threads? And what do i torque them to ?
  5. Can you tell me where you got the harness for the sensors? i bought the harness at lexus lexus
  6. ericok the big problem is that it will not shift into overdrive with this fault. is the left bank the front bank. i do not want to take that manifold off again. do you mean splice the wires on the new harness where they are accessable. i will not be able to determine which wire goes to the left bank without taking the manifold off. i could always do the trial and error method. to see which wire goes the the right sensor, or the good sensor. have you tried this before thanks tim
  7. ericok yes i cleared the code several times. thank you for the info that's it for this vehicle! off to the auction.
  8. i had some transmission work done and it appeared they damaged the harness. i removed the intake manifold then changed the harness and still have a 0330 fault (knock sensor circuit fault). now that i have the old harness, is there a way to rewire the ends that go to the sensors to fool the computer. or does anyone know the sensors work? do they create a resistance in the circuit or are they straight to ground?
  9. THANK YOU FOR YOUR HELP I WILL PUT MY INTAKE ON SUNDAY
  10. HAVE YOU USED THESE VALUES 11 FT/LBS FOR THE LOWER MANIFOLD AND 32 FT/LBS FOR THE UPPER MANIFOLD? 32 FT/LBS SOUNDS HIGH FOR ALUMINUM
  11. WHAT ARE THE TORQUES FOR INSTALLING THE INTAKE MANIFOLD AND ALSO THE PLENIUM? I HAD TO CHANGE THE KNOCK SENSORS HARNESS.
  12. WHAT ARE THE TORQUE VALUES FRO THE INTAKE AND THE PLENIUM
×
×
  • Create New...

Forums


News


Membership