Philhawtin

Its Completly Dead... I Get Absolutly Nothing, No Sounds, Efforts, Nothing

My driver and passenger mirrors dont work, is it the motor, the switch on my panel?? i dunno. any one with past experience with this. Please hook It Up.

Hey Bro, I Have The Same Car And Problem. I Am Getting Daizen Lower Controll Arm Bushings Put On As Im Writing This, After I Pick It Up I Have To Take About A 100 Mile Road Trip SomeWhere, Ill Post Maybe Tonight Or Tomm. And Let You Know The Results. Best Of Luck To Ya

I Appreciate all your help with this, and yes i am 99 % sure i micht have a broken plug wire.. thanks again everyone

Hey All I Have A 93 SC400 Pearl White and a stock engine. for about 2 months i have had a vibration in my engine when say the car is park or neutral, i hold steady RPM's at pretty much any range. i usually go for about 2k rpm's and a vibe. will start about 3 seconds, then go away and then all is perfectly smooth, then another 3-4 seconds later, it comes back. its repetitive and a nuescence it does it while driving down the road too. but just as an example. i took it to my old work place, (automotive diesel, ) and hooked up our snap-on modis, (Scanner) and found 2 codes yet no check engine light, and both codes were for air flow sensors, meters, or what ever. well my buddy was cheking each channel of the MAF wiring harness, 4 wires and the modis was placed on the driver side of the car and the wires were stretched over to the mass air flow center. and he could not get readings cause when he had the cords close to the engine he was getting too much interference from the engine, so maybe i though it might be bad wires somewhere??? oh and p.s., i checked all vacuume hoses thanks all help would be appreciated! Phil

"I don't know if the supra bar will work, but I found this on ebay specifically for the sc400 http://cgi.ebay.com/ebaymotors/LEXUS-SC400...078564111" I Bought That Strut Bar And Its Pretty Darn Weak, not So Much at the mid point, but the black metal where you mount to the car is quite flimsy... i would advise against it... and by the way thanks for this thread. i have often wondered this question in searches of my own. Phil

If your status is New Club Member then you are not allowed to post in this forum. You must make a contribution to the forums before you can post here. When you have made enough posts, your status will change, and you will be allowed to post. This has become necessary due to the number of people registering purely to sell, and not contributing to our communitylbums/y42/phily_29/MyBabies.jpg edited by SKperformance.