drdfblackm

Ok I have a 2006 GX470 and the driver sensor was bad...completely corroded to death. Ok I installed new sensor, but I feel either the left or right or both need to be adjusted. The rear does go up and down now. but I feel that "Normal" is too high in the rear and "Low" does not drop the suspension all the way to the bump stops. I removed the right side to look and see if it was bad (corroded on the inside) and it looked fine. So I am looking for page 25-3 of the shop manual that tells how to properly adjust the sensors. Any help would be greatly appreciated.

Most likely one of the sensors is bad. They are not hard to take off. In some cases they just need to be taken apart and cleaned. In my case one was corroded so badly it had to be replaced.