Jump to content

Heavymental

Regular Member
  • Posts

    16
  • Joined

  • Last visited

Everything posted by Heavymental

  1. im about to replace my HP steering hose on my 95 LS. i dont have any larger open wrenches and wanted to know this nut size before i DIY this. i think its 21mm but wanted to confirm. see pic, red arrow:
  2. you said you dont have to remove the EGR, but in one of your pics i see it taken off from the upper EGR two bolts. Do you just have to remove the bolts to make it loose?
  3. got a 95 LS trying to do the drivers side tie rod, inner and outer. i got the castle nut off but i cant get the tie rod out. i hammered it a little still wont budge. do i really need the tool?
  4. i have a 95 LS400- the wheel shakes at 50+mph. i checked all joints, the strutrod busings look worn. theres also play at 3 and 9 position when i have the wheel jacked up. i put some pressure with a bar on the strut rod and has some play to it. what is the best option replacing the entire rod or pressing in new bushings?
  5. my car would die after sitting 3-4 days. Car is all stock, stereo changer is stock.
  6. i have a battery drain, ive check my alternator ps fluid leak etc all is good there. i put a meter to the battery and got the following readings: 0.18 amp radio fuse pulled it read 0.05 does the CD changer eject button suppose to work while key is out/car is off?
  7. thanks guys, ill just drive it and keep a look out on the belt.
  8. i dont know, the belt has a lot of push back to it. this all happened when i left the car sitting for about a week and it wouldnt start. i then jump started it and put the meter to it. With the headlights on the meter dropped a bit. The belt does not squeal heavily, i would sometimes barely squeal for a few seconds on some starts. alternator was replaced 4-5k miles ago.
  9. my drive belt on my 95 ls400 seems to be a bit loose. When i press down on it with my finger the belt moves quite a bit. The belt condition is fine. im only getting about 13.5 volts when motor is running. is it the tensioner? or ilder pulley?
  10. youre talking about the switch thats located in the door?
  11. my dome light, courtesy lights over brake pedal and ignition key ring wont light up when i open the doors. The door open indicator on the dash works. The dome light turns on when the switch is turned manually to the ON position. its a 95 LS400. all fuses look good.
  12. i can see exhaust air shooting out when i start up. can i change out the 2 gaskets without removing the entire exhaust system?
  13. it only happens sometimes no brakes being applied . only on a full left turn. my power steering system was done by dealer. i know my alignment is slightly off, the wheels turns to the right a little while driving. i will try to get it assessed a the alignment shop.
  14. 95 LS, i have a exhaust leak at the joints after the cat on both sides. Its leaking at the joint/gasket area. Wondering if i should remove the piping and put in new gaskets or use some cement, exhause sealer. What do you guys recommend?
  15. you mean obd code scanning? i ran obd scan there are no codes. i guess ill check the abs wire, there are no abs lights.
  16. 95 LS400 i have this strange pulsing thumping vibration on full left turns at low speeds. In parking lots. Almost like the abs is pumping sort of vibration. i jacked the car and inspected for loose parts, nothing. Theres no play/shake in the wheel. Lugs are tight, front lower ball joints were done about 10k miles ago. Power steering system was done by dealer. tie rod has no play, CV boot looks sealed no cuts. i dont get it.
×
×
  • Create New...

Forums


News


Membership