A quick look as FSM says you should do this next
5. INSPECT CAMSHAFT POSITION SENSOR
(a) Disconnect the sensor connector.
(b) Using an ohmmeter, measure the resistance between terminals.
Resistance:
Cold 835 - 1,400 W
Hot 1,060 - 1,645 W
If the resistance is not as specified, replace the sensor.
© Reconnect the camshaft position sensor connector.
6. INSPECT CRANKSHAFT POSITION SENSOR
(a) Disconnect the sensor connector.
(b) Remove the bolt holding the connector bracket to the water
pump.
© Using an ohmmeter, measure the resistance between terminals.
Resistance:
Cold 1,630 - 2,740 W
Hot 2,065 - 3,225 W
If the resistance is not as specified, replace the sensor.
(d) Reinstall the bolt holding the connector bracket to the water
pump.
edited to try and get back readable format.
(e) Reconnect the sensor connector.