Jump to content

Reset or Reprogram Yr-2005 SC430 window auto-up/auto-down - Help


Weekend_DIY

Recommended Posts

Hello, This is my first post.  I searched all posts, forums, youtube videos and manuals I could find. HELP.

My SC430 is a Yr02005 with 29,000 miles. I changed my front speakers (6.5"). I did not touch the window motors. Now my passenger window will only work with manual operations. i.e. I have to hold the switch to make it go up or down.

Steps: I disconnected battery. Then removed door panel, connectors to door latch, door light, and removed connection to passenger door ECU.  Then I replaced the speakers. Now, connected everything back. Before closing up, I'm testing everything. The speaker works. The door lock/unlock works. The open/close doors and windows with Keys work.  EXCEPT, the passenger window goes down or up only a little.

To reset the window SC430 manual gives these steps:

(a) Install the front door window regulator with the 7 nuts.Upper side:Torque: 8.0 Nm (82 kgfcm, 71in.lbf) Lower side:Torque:13.0 Nm; m(133 kgfcm,10ftlbf) Motor side:Torque: 5.5 Nm ; (56 kgfcm, 48 in.lbf)

(b) Install the power window regulator and door glass.

(c) Connect the power window switch to the wire harness and turn the ignition switch ON.

(d) Fully close the door glass by manual operation.

(e) By using a round bar (2 mm) keep the reset switch pressed.

(f) Fully open the door glass by manual operation (Push the down switch) with the re-set switch pressed.

(g) Take the round bar away from the reset switch and then fully close the door glass by manual operation.

(h) Check if AUTO UP/AUTO DOWN operates in the automatic operation.

(i) Reset the regulator again when performing the reverse operation after closing the window fully by AUTO UP operation.

(i) Check the power window function.

Link to comment
Share on other sites


Hi, I figured it out.  There are 3 connectors to the door ECU. The far right connector that is closest to the door latch was not snug.  I believe this is what controlled the auto-up/down feature.  I retraced my steps and with help of other's suggestions, I found the problem and the window works now.  Thank you.

  • Like 2
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



×
×
  • Create New...

Forums


News


Membership