Jump to content

Climate Control


agiles212

Recommended Posts

And I'm back. .....I recently replaced my blower motor and the resistor in my 199 ls400.... During the install I ran into a minor problem where the car wouldn't start. . But after great feed back from the forum and trouble shooting I located the problem...it was a connector that was not properly connected. Now the issue is. ... blower motor works fine however, my climate controls only work on High(even tho it's blowing like its on med) while the Lo and Med controls do not cycle through. The temp control works and the blower is blowing the heat but not adequately into the vents......Any suggestions?

Link to comment
Share on other sites

That being the case, maybe bad/wrong resistor pack, new blower motor is sluggish or wrong type, or something misconnected. For one thing, at high speed, you should find almost 12v on the blower motor. You are going to need to get back in there and make some checks. Win one for the Gipper. ;-)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



×
×
  • Create New...

Forums


News


Membership