jerzyjim Posted December 27, 2008 Share Posted December 27, 2008 I went to AutoZone this morning and they read my CEL code. It was PO401 and the definition was too little flow on the EGR system and follows; 1. Blocked passage on EGR system. 2. Failed EGR valve. 3. Failed EGR pressure sensor where applicable. 4. " " position " " " ...... Has anyone run into this problem, ( the car runs great and MPG are great ),and if so , any suggestions ? Has anyone used Seafoam in the intake and would this possibly take care of this problem. thanx for any help, jerzyjim Quote Link to comment Share on other sites More sharing options...
eatingupblacktop Posted December 27, 2008 Share Posted December 27, 2008 Check your egr vacumm modulator filter. See if that fixes your cel. Here's the HTD: http://www.lexls.com/tutorials/emission/egrfilter.html Quote Link to comment Share on other sites More sharing options...
jerzyjim Posted December 27, 2008 Author Share Posted December 27, 2008 Check your egr vacumm modulator filter. See if that fixes your cel. Here's the HTD: http://www.lexls.com/tutorials/emission/egrfilter.html Mr. Motorhead, thank you very much for the info. My engine doesn't look like that; ('97 sc300 I6 cyl ) thanx again, jerzyjim Quote Link to comment Share on other sites More sharing options...
jbarhorst2 Posted December 27, 2008 Share Posted December 27, 2008 I had the same problem on my car. I cleaned the EGR valve itself and changed the EGR temperature sensor. Neither fixed the problem. Finally when I needed a new head gasket I had the head cleaned and a valve job done. Once I did this work, no more problem. I assume the passages were partially plugged. Tom Quote Link to comment Share on other sites More sharing options...
eatingupblacktop Posted December 28, 2008 Share Posted December 28, 2008 Check your egr vacumm modulator filter. See if that fixes your cel. Here's the HTD: http://www.lexls.com/tutorials/emission/egrfilter.html Mr. Motorhead, thank you very much for the info. My engine doesn't look like that; ('97 sc300 I6 cyl ) thanx again, jerzyjim Now you tell us! Why didn't you put that in your original post? You should update your profile info. Quote Link to comment Share on other sites More sharing options...
N.C.O. Posted December 28, 2008 Share Posted December 28, 2008 Check your EGR valve, by applying vacuum directly to the valve, if the engine doesn't run rough or stall, the passage in your intake is probably restricted. N.C.O. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.