Sign in to follow this  
pcroland

Wiring 4 Ohm Dvc Subs

Recommended Posts

Hey all,

I have 2 12" 4 ohm DVC subs(solo-baric 12L54), and a 2000W 4 CH amp (2 ohm) ...the amp is 1000x2 (4 ohm) bridged ...the question is, what would be the best way to wire this for maximum production?

..I was planning to wire the 2 coils on each sub in parallel which would make them 2 ohm ..and have the amp bridged 1000x2 push them ..but not sure if this would be a problem with the sub at 2ohm and the amp at 4 ohm?

..I welcome any suggestions.

Roland

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this