Ken_303 Posted September 24, 2004 Posted September 24, 2004 Ok, think I must have some kind of short but thought I'd try for some input. When I bought my 94 GS, the drivers front turn signal bulb was out. Naturally, the rectangular amber light on the dash was lit. I replaced it. No sooner did I do that and the rear blinker went out too. Ok fine, replaced that too. Now I CANNOT find ONE bulb out ANYwhere on the car but the damn thing is lit again. I did notice that it didnt initially light up until I hit the brake, but the bulbs are good. Anyone have any tips? Kind of frustrating.
Thienn Posted September 24, 2004 Posted September 24, 2004 The sensor sense the current thru the lighting systems and a low/high current will trigger the warning light! There are two main cause for this: there might be a loose ground wire(s) some where. Check all contact to make sure you have a good connection! Also, the light (s) might draw less current as it wearing out so replace all light will correct the problem. I would recommend you check all the connection first so you don't waste money on new bulb! Good luck.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now